Cleaning luminaires

Luminaires should be cleaned at the same time as relamping.

Reflecting areas should be cleaned when dust and other contamination are noticed.

Electrical components and cables must not be exposed to cleaning agents or water.

It is important that the voltage supply is disconnected before starting to clean the luminaire body.

The reflectors and active louvers used in out T5 Flourescent luminaires are designed For maximum efficiency and controlled light distribution. This makes it Possible to plan lighting for energy efficient solutions.The collective qualities of the T5 combined with adapted light processing usually gives an efficiency increase of at least 35% in comparison with applications based on the T8 light source (26mm)

An important part of the system is the choice of the reflector material.

Our louvers has enhanced reflection properties, makes up the basis of our reflector material in combination with the T5 light source. All with the intention of making energy savings and in doing so reducing the impact on our environment.

-61 is a semi-specular natural finished anodized aluminum reflector. It is a double semi-parabolic louver with a deep side semi parabolic cross blades.

-62 is a specular natural finished anodized aluminum reflector. It is a double semi-parabolic louver with a deep side semi parabolic cross blades.

-63 is a specular natural finished anodized aluminum T5 flourescent reflector. It is a double semi-parabolic louver with a deep side semi parabolic cross blades.